Advertisment:

Author Topic: Support for Ubiquiti UniFi UVC?  (Read 2415 times)

Offline SveinHa

  • Newbie
  • *
  • Posts: 6
    • View Profile
Support for Ubiquiti UniFi UVC?
« on: July 02, 2014, 06:16:38 am »
I'm about to buy a couple new cameras and are using , among several others, Ubiquiti Aircam now. Ubiquiti have recently released their UniFi UCV cam, do BlueIris support that?

Offline SveinHa

  • Newbie
  • *
  • Posts: 6
    • View Profile
Re: Support for Ubiquiti UniFi UVC?
« Reply #1 on: July 16, 2014, 06:31:35 pm »
Well, now I can ansver this myself: UniFi UVC can ONLY be used with Ubiquiti UniFi NVR so these cameras is money down the drain... >:( >:( >:(

Offline VRC

  • Newbie
  • *
  • Posts: 23
    • View Profile
Re: Support for Ubiquiti UniFi UVC?
« Reply #2 on: August 27, 2014, 02:41:14 pm »
Thanks for the info, I was about to order some Unifi cameras, but I will get the Aircam's instead.

Offline jayson

  • Hero Member
  • *****
  • Posts: 1562
    • View Profile
Re: Support for Ubiquiti UniFi UVC?
« Reply #3 on: August 27, 2014, 09:27:19 pm »
Thanks for the info, I was about to order some Unifi cameras, but I will get the Aircam's instead.
There are way better choices than the aircams....check out hikvison and dahua

Offline red3recon

  • Newbie
  • *
  • Posts: 2
    • View Profile
    • Email
Re: Support for Ubiquiti UniFi UVC?
« Reply #4 on: May 09, 2016, 04:00:35 am »
I am sure this is updated somewhere but I will post this as it is the #6 hit on google still.
 
Yes, the UVC cameras will now work with Blueiris! It sucks that I have a mixed model setup now as I needed some IR cameras and could not use these.
 
UVC Dome Camera with firmware version UVC.v3.2.0.57.a32ae49.160411.03 has a RTSP Stream section under the "Configure" area.  In it they put the path at /s0 (rtsp://10.0.0.220:554/s0 for example)
 
In Blueiris configure the camera as Ubiquiti, Airvision RSTP for model and then /s0 for the path.  That with the correct username and password works for me!  I did not ensble the "RSTP Authentication" option in the cameras firmware.
 
Hope that helps somone doing a quick google check.

    Advertisement


 

    Advertisment:

Mobile Theme